Intec Heel Mechanism Kit

[dbmgreen]

Is it possible to replace the plastic tread (Heel Pads) on the Intec Heel Mechanism Kit?

[corey_dyck]

For the Fintecs: http://bomberonline.3dcartstores.com...ads_p_136.html

For the F2s: Shoe Goo. Actually, Shoe Goo works pretty well on the Fintecs too!

[dbmgreen]

When you refer to f2s are they the ones made by Caron Alpine http://www.catek.com/catekdirect/pro...p?productid=10? So if the heel pad wears out, do you just fill the space with shoo goo? While i'm at it, do the fintecs work OK with f2 bindings?

[www.oldsnowboards.com]

When you refer to f2s are they the ones made by Caron Alpine? Not made by Catek, they are F2 "Intec" brand.
So if the heel pad wears out, do you just fill the space with shoo goo? Sorry, no knowledge of this.
While i'm at it, do the fintecs work OK with f2 bindings? Yes, You must of course have Intec compatible bindings.

FYI. F2 is a competitors product, Bomber was sued by someone involving the Intec product. Touchy subject . They are NOT sold here. Bomber built a very strong replacement heel called the "Fin Tec" , they ARE sold here.
CATEK is also a competing product. Although the company has sort of fallen on hard times evidently.

Good luck.

[corey_dyck]

F2 heels: http://www.yyzcanuck.com/store/INTEC-Heel-Kit.html

Just like with shoes (what it's designed for), you put Shoe Goo over the worn-out part so you have fresh material to wear out. Clip your boot in first and make note of what areas come close or contact the binding so you don't change that relationship by putting a bunch of stuff between them. This wasn't an issue with the Fintec heels in a TD3 binding as there's lots of room, but check anyway to be sure.