WTB: 4-hole cant for Burton Race Plate binding

[jim_stoll]

Desperately seeking one 4-hole cant plate for my Burton Race Plate, or a 4-hole insert that will work with my existing 3-hole cant setup.

Thanks!!

Jim

[bumpyride]

Have one 4 or 3 hole cant left. Consists of two 7" disks and a metal spider. Goes from 1 to 8 degrees and can be turned to include a bit of heel lift if you so desire. These are Burton's. $30 postage paid.

[jim_stoll]

Bumpyride - that sounds perfect. Just to confirm, that'll bolt up to my Race Plate bindings, correct? (I have both a 3 and 4 hole disc now, so can go either way on the binding-to-cant mount)

How does that work? I'm guessing that you swivel the plates in relation to one another to get the desired cant? What's the metal spider for?

Tell me how I can get payment to you. If you can accept PayPal, that'd be quickest and easiest, but failing that, I can get a Money Order out in the mail first thing tomorrow morning. (I need to have the 4-hole cant in-hand w/in the next 2 weeks, so speed is of the essence for me... :-)

Thanks for replying!!!

Jim

[bumpyride]

Spider sit directly on the board with 3 or 4 hole configuration attached with 3 or 4 short screws.

Bottom half of disk has grooves that fit over the 4 legs of the spider preventing the disk from rotating. These grooves run completely around the disk to accomodate heel lift and cant.

The top disk fits into the upper grooves of the plate and also rotate to allow changing cant from 0 to 8 degrees.

The spider has a locking dog and machine holes for binding screws. You mount the binding directly to the spider.

You could Paypal me at my email address yacantbuycool@comcast.net. and I could ship those out in the next day or two.

[jim_stoll]

Bumpyride,
Please check your email for a quick question.

Thanks!